The new powerful electronics for any RepRap!
Megatronics is based on many famous open-source products including: Arduino Mega, RAMPS, SD Ramps. Therefor this product is an already proven design. It combines all major features of these board into a single board solution for more reliable 3D-printing. This board will get you the most features for the best price!
Megatronics has a powerful Atmega2560 processor with 256 kB memory, running at 16Mhz. The board can be connected to a PC using a normal USB cable. It will register as FTDI FT232R device. The board is compatible with the Arduino Mega 2560 and will therefor be easily programmed from the Arduino IDE.
This is only the board. Stepper drivers are not included.
Powerful Atmega2560 processor with 256 kB memory, running at 16Mhz
Thermo couple (2x)
On board support for connecting two thermo couples
Autonomous printing from Micro SD card on board, also an external SD card is supported
Hooking up a LCD is pretty easy. The Wiring is compatible with most LCD screens. We do not sell the required wiring yet, but you can use 6x2-wire cable.
The board has 3 MOSFETs (3x 25A) to support extruders, 2 MOSFETs fior fans and 1 MOSFET (IRLS3034PBF) for the heated bed
Four thermistors are supported.
Up to 6 stepper drivers
Compatible with RAMPS, 6 slots for stepper drivers (not included). Modularized to make replacement easy for damaged drivers. This board also support the new DRV8825 driver from Pololu http://www.pololu.com/catalog/product/2132.
Support for many peripherals
The board's functions can be easily extended with LCD, keypad etc. See the connectors section for more information
- USB 2.0 Full Speed compatible
- Auto reset can be disabled by removing a jumper
- The board can be powered from 12V1 (12V MAX), by setting a jumper
- The LCD contrast can be adjusted with a trimpot
- The 5V line is protected by a 500mA resettable fuse
- A piezo is included to allow the printer to give feedback with sound
- Each stepper driver slot has a breakout to connect external stepper drivers to the board.
- Four layer high quality PCB board
Datasheet: Coming soon
Marlin firmware: See download section (service -> software downloads)
This is a kit of the following items.
|6x||2-wire 24AWG cable, Red Black (1m)|
|1x||Megatronics v3.3 - Basic kit|
|4x||NEMA17 Stepper motor / 1.8° step / connector / flat shaft / 5.0 kg.cm|
|4x||Connector cable for stepper motor / 100cm / 4 leads|
|1x||Heater wire 18AWG/5A, black ( per meter )|
|1x||Heater wire 18AWG/5A, red ( per meter )|
|1 - 9:||excl € 170.04 incl € 205.75|
|10 - 29:||excl € 161.54 incl € 195.46|
|30 - :||excl € 153.04 incl € 185.17|
|Need a larger quantity? Contact our Sales department.|